Now, let’s look at the different modes on the control panel.
Pressing
M
will cycle the spa through different modes manually. The different modes are:
NOM
– normal operation
NOM ECE
– normal mode for 1 hour, then economy mode automatically
ECE
– economy mode
FIL
– filtration mode
What do these modes mean?
NOM –
The system is in normal operation, the heater is on (if the desired temperature isn’t reached)
ECE –
the system will only heat the water during the pre-determined filtration cycle
FIL –
the system is in filtration mode. The heater will not be in operation. Manually using the filtration
mode is only needed if the system has been switched off for long periods of time.
If you are going to be using the spa on a regular basis, every day or every two or three days, set the spa to
NOM
so that the spa will always be hot for you. You can then use the arrows to adjust the minimum
temperature that you want the spa to remain at.
When the water temperature falls below 6.7
o
C the spa will switch to anti-freezing mode. All the pumps and
blowers will operate for 30 seconds and then turn off. All the heaters and circulation pumps will switch on. The
panel will show
ICE.
Pressing this symbol switches on the LED lights. They will cycle through various
colours. Press the button again to stay on a specific colour, and again to switch the
lights off. The lights will automatically shut off after 2 hours.
Pressing this symbol switches on the air blower. The blower will automatically turn
off after 25 minutes.
Pressing this symbol switches on the jets and fountains.
