Danube WED 10, Instructions For Installation, Use And Maintenance Manual

Page: 87 / 105

43
5.1 Create phase name
This command allows for the creation of a phase name. The steps to follow are the
following:
¾
After selecting CREATE PHASE NAME, press the ENTER key:
CREATE PHASE NAME
A
¾
With the INC (
∧
) and DEC (
∨
) keys, the character where the cursor is can be modified;
with the ADVANCE key (>>) the cursor goes on to the next character; the INFO key
changes from upper to lower case and to special characters. Once the name has been
written, press ENTER.
Save phase?
ENTER: Accept
ESC: Cancel
¾
If you wish to return to the previous menu you should press the ESC key.
5.2 Copy phase name
This command allows for copying the name of phase from an existing one. The steps to
follow are the following:
¾
After selecting COPY PHASE NAME, press the ENTER key and the name for the first
phase name saved in the memory will be displayed.
COPY PHASE NAME
Pre-wash