Dantherm MASTER CLIMATE SOLUTIONS B 35CED DV, User And Maintenance Manual, Page: 10 / 24

► VI°. For the models with room thermostat,
check the position of the knob
(SEE FIG.
5-9) .
N.B.: IF THE HEATER SHOULD SWITCH-
OFF DUE TO THE LACK OF FUEL, TOP-UP
THE TANK AND RESET THE HEATER (SEE
PAR. 6.2).
6.2 RESETTING THE HEATER:
► I°. S witch the heater off and back on again
(SEE FIG. 3-4) .
6.3 SWITCHING THE HEATER OFF:
►
I°.
Take the “ON/OFF” switch to the “OFF”
(O) position (SEE FIG. 3-4) .
7. REGULATING THE
PRESSURE OF THE
COMPRESSOR
(SEE FIG. 7)
THE COMPRESSOR PRESSURE MAY
HAVE TO BE RESTORED WITH WEAR OF
THE HEATER.
► I°. Use the “TECHNICAL DATA TABLE”
to identify the correct pressure (Bar - PSI -
kPa) of your heater.
► II°. Remove the screw/cap of the manometer
connection
(A)
.
► III°. Assemble the manometer (not supplied,
see
“ACCESSORIES”
).
► IV°. Switch the heater on.
► V°. Act on the regulation screw by turning
it clockwise to increase the pressure and
anti-clockwise to decrease it (B) .
►
VI°.
Remove the manometer and restore
the screw/cap (A) .
8. CLEANING THE TANK FILTER
(SEE FIG. 8)
DEPENDING ON THE QUALITY OF THE
FUEL THAT IS USED, THE TANK FILTER
MAY HAVE TO BE CLEANED.
►
I°.
Remove the cap
(A)
from the tank.
► II°. Extract the filter (B) from the tank.
►
III°.
Clean the filter
(B)
with clean fuel,
paying attention not to damage it.
► IV°. Re-mount the filter (B) in the tank.
►
V°.
Close the cap
(A)
.
9. PRESERVATION AND
TRANSPORT
I ORDER TO KEEP AND/OR TRANSPORTAR
THE HEATER IN THE BEST WAY, STHE
FOLLOWING PROCEDURE MUST BE
FOLLOWED:
►
I°.
Empty the fuel tank (some models have
a draining cap on the bottom of the tank. In
this case, remove the drain cap and empty
the fuel).
► II°. If the presence of residues is noted, pour
clean fuel into the tank and drain off again.
► III°. Close the tank cap and/or the draining
cap and dispose of the fuel appropriately
according to the Standards in force.
► IV°. In order to keep the heater in the best
way possible, it must be kept on a level
surface to prevent the escape of fuel and in
a dry place away from any possible external
threats.
10. ROOM THERMOSTAT
CONNECTION (...CED) (optional)
Remove the plug connected to the appliance
and connect the room thermostat (optional)
(SEE FIG. 9) . See wiring diagram.
en
it
de
es
fr
nl
pt
da
fi
no
sv
pl
ru
cs
hu
sl
tr
hr
lt
lv
et
ro
sk
bg
uk
bs
el
zh