5
camera pedestal if you want to draw out the cable from the side port of the cable channel when
you are installing the device cable. And then you can draw out the cable from the cable channel
of the pedestal.
Step 3
Adjust the device installation pedestal to the proper position and then draw the cable through the
cable exit you just dug in the ceiling (wall). Line up the TOP direction of the device to the
installation position map and then line up the three screw holes in the device pedestal to the
three plastic expansion bolt holes in the installation position. Put the three self-tapping screws in
the three plastic expansion bolts firmly. Now the dome camera is secure in the installation
surface.
Step 4
Loosen the two M3 secure screws of the lens rotation structure (Do not remove, loosen a little bit
will be OK.). Use the inner hexagonal wrench to insert them to the inner hexagonal holes and
then use the wrench to turn the lens. Adjust the lens to the proper monitor angle and then secure
the screws of the lens rotation structure. The lens adjust angle ranges are: flip (0
°
~+75
°
),video
pan rotation (-15
°
~+15
°
) , video rotation angle(-15
°
~+15
°
).
Step 5
Line up the dome camera cover to the cable exits and put the cover back. Use the inner
hexagonal wrench to secure the three inner hexagonal screws firmly. Now the installation
completed.
Note:
The device GND cable can effectively enhance the device reliability. The GND hole is near the
cable exit of the back of the enclosure. The GND screw specification is M3. See Figure 2-3.
Figure 2-3