11
STEP 3
Put power supply, video output, RS-RS-485 control input wiring through waterproof connector plugs, and
connect them correspondingly to power supply, video, RS-RS-485 wiring of the connecting cable.
Connect the cable refer to the following picture:
Remark: Cable can be from either side or bottom.
Or put the wiring through the waterproof connector plugs and joint them on the supplied 12 cores vacant connector
plugs. Tighten the waterproof connector plugs when finish connecting.
STEP 4
screws loose the nut cover on the camera, then you will see the 8 bit dip switch. Set the protocol, baud rate,
address for the camera. Screw tight the nut cover when finish setting.
STEP 5
turn on the power after finishing check
Nut cover
SW1/SW2 dip switch