6
H
H
OW
OW
Y
Y
OUR
OUR
A
A
PPLIANCE
PPLIANCE
W
W
ORKS
ORKS
Cautions
:
Do not try to operate your stove with viewing door open. Pellets will not feed under these
circumstances and a safety concern may arise from sparks or fumes entering room.
If you are not drawing combustion air from outside, care must be taken to allow for adequate air
make up, to avoid possible room air starvation when stove or other exhaust fans are in
operation.
It is highly recommended that you install a high quality
smoke detector
as well as a
carbon
monoxide gas
detector in the room where stove is installed. Care should be taken to make
sure detectors are in working order at all times.
Fuel in the form of wood pellets , shelled corn or grain is stored in the hopper. An
auger delivers the pellets to the burn grate. The fuel rate, or heat output, is set by
adjusting the feed rate touch pad, (settings 1 to 4). A fan provides combustion air to
the burn grate. The amount of combustion air in the burn grate is adjustable and
automatically changes as the fuel rate changes. The higher the fuel rate, the larger
the amount of combustion air and visa versa. The fuel burns in the burn grate,
producing heat. Some heat radiates out the front of your stove. The majority of the
heat passes around the heat exchange tubes and air plenum around the firebox and
is then moved into the room by the room air fan. A small amount of heat must pass
out the exhaust of your stove, along with gases, into the atmosphere.
Your stove's heat output can be adjusted from setting 1-4, through the FEED RATE
touch pad, to vary your heat output from Low to High. The room air fan can be
manually adjusted through the FAN SPEED to run faster or slower to correspond to
the amount of heat being produced. The room air fan is also on a limit switch,
controlled to run on high when the stove reaches higher temperatures and then
resume the speed you had selected once it cools to a lower temperature.
Your stove
can run
efficiently over extended periods of
time and at different heat output
levels as long as the fuel supply is
uninterrupted and
timely cleaning
and maintenance is preformed
.
An example of how improper cleaning
effects operations is; the
exhaust pressure switch will shut the
pellet supply off and your stove will
shut off if the exhaust system
becomes plugged.
The operations and maintenance of your
Glow Boy
Series of multi-fuel appliance are unique
and
should not be considered to be like a wood, coal, gas, electric, propane or oil heater, stove or appliance.
FUEL CONSIDERATIONS
Your
Glow Boy
Series of Multi-fuel appliance
i
s
designed to burn the following:
1.
Wood pellets that comply with the Pellet Fuel Industries standards.
2.
A combination of up to 50/50 Wood Pellet and Shelled Corn
3.
100% Shelled Corn or Grain, using the Multi—Fuel Grate, and manual start only, No Igniter.
as desired
as desired
Memory &
Fan Trim
Glow Boy Pellet & Biomass
www.glowboystoves.com 6
Window
Burn Pot
Burn Grate
Heat Tubes
Tube Scraper
Hopper
Fan Motors
Auger
Exhaust
Air Intake
Auger Motor
Ash Pan
