DMR-6 Mid-Rise Scissor Lift
19
P/N 5900253 — Rev. A — August 2020
Connect the Power Unit
The standard Power Unit for your Lift comes fully assembled from the factory, configured for 115 VAC
operation.
If you have a 220 VAC Power Unit, it will come with a pigtail for wiring to a power source. Have your
Electrician remove the pigtail and wire from inside the Electrical Box on the Power Unit to an
appropriate Power Cord and Plug.
Important electrical information:
•
Improper electrical installation can damage the Power Unit motor; this damage is not covered
under warranty.
•
Use a separate circuit breaker for each Power Unit.
•
The circuit must be grounded and protected with a time-delay fuse or circuit breaker. For a 115
VAC, 1 phase circuit, use a 20 amp or greater fuse. For a 230 VAC, 1 phase circuit, use a 25 amp
or greater breaker.
⚠
DANGER
All wiring
must
be performed by a licensed, certified Electrician.
⚠
CAUTION
The Power Unit’s Motor is
not
thermally protected.
The following drawing shows the Power Unit for your Lift (220 VAC option only).
To connect to a power source
:
1.
Find the Power Cord on the Power Unit, and then make sure the Power Cord has an appropriate
plug on the end.
Important
: If you have a 220 VAC Power Unit, have your Electrician put a 220 VAC Plug
appropriate for your location.
Remember, all wiring must performed by a
licensed, certified Electrician for this process.
2.
Plug the Power Cord to an appropriate power outlet.
3.
Begin using the Lift.
Summary of Contents for DMR-6
