Dangrill 95307, Instruction Manual

Page: 32 / 58

32
Position the gas hose so that it does not
come into contact with hot parts of the
barbecue and keep it straight.
Only use gas hoses approved by the relevant
national authorities. The gas hose must be a
maximum of 150 cm long and must be � tted
with an approved regulator.
Check regularly that the gas hose is
not cracked or crumbling and replace if
necessary.
The gas bottle must be placed next to the
barbecue.
It must not stand within the actual barbecue.
The gas bottle must be changed outside at
a safe distance from naked � ames and other
sources of ignition.
If you discover a leak, turn off the gas supply
at the regulator immediately and avoid
naked � ames and other sources of ignition.
Wait a few minutes until the area has aired.
Carry out a leak test when you connect a new
gas bottle or if the barbecue has not been
used for a prolonged period. Do not carry out
the leak test using a naked � ame! See “Leak
test”.
Turn off the gas supply using the regulator
after use.
Do not attempt to modify the barbecue,
including the regulator and the burners.
Do not try to open parts that have been
sealed at the factory.
Assembly
Please refer to the illustrations
at the back of the user
instructions. It takes 2 people
to assemble the barbecue.
Before assembly, you must unpack all parts
(including those inside the � re box) and lay
them out in a clear manner.
Where appropriate, place them on the
packaging or a rug so that the barbecue
and its parts do not get scratched while you
assemble the barbecue.
Wait until the end to tighten all screws,
bolts and nuts. All the barbecue parts are
manufactured very accurately relative to � t,
and if you tighten something slightly askew
or too tight, it can aff ect the assembly
elsewhere on the barbecue.
Use
1. Turn all the control knobs to the
position .
2. Open the lid before use.
3. Connect the regulator to the gas
bottle. Set the gas supply to ON on the
regulator. Use soapy water to check for
any gas leaks between the gas bottle
and the regulator.
4. Press the control knob down, and turn it
anticlockwise to the large position.
A clicking sound will be heard, and
the burner will ignite. If this does not
happen, repeat the procedure 3 or 4
times.
5. If the burner still does not ignite, wait 5
minutes and repeat point 4.
6. Once the burner has ignited, repeat
points 4 and 5 to ignite the other
burners.
7. Regulate the heat by turning the knob
to the High/Low position.
8. Turn off the regulator to turn off the
barbecue. Then turn all the control
knobs on the appliance clockwise to
position .
Warning : If a burner cannot be lit,
the control knobs must be turned to
(clockwise) and the regulator closed. Wait
� ve minutes before you try to light it again
by following the ignition procedure.