Danfoss VLT OneGearDrive, Instruction Manual

Page: 6 / 40

1 Introduction
1.1 Purpose of this Instruction Manual
The purpose of this instruction manual is to describe the
VLT
®
OneGearDrive. This instruction manual contains
information about:
•
Safety
•
Installation
•
Commissioning
•
Maintenance and repair
•
Specifications
•
Options and accessories
NOTICE!
For reasons of clarity, the instruction manual and safety
information do not contain all information relating to all
OneGearDrive types and cannot take into account every
conceivable case of installation, operation, or
maintenance. The information is limited to what is
required for qualified personnel in normal working
situations. Contact Danfoss for further assistance.
This instruction manual is intended for use by qualified
personnel. Read this instruction manual in full in order to
use the OneGearDrive safely and professionally. Pay
particular attention to the safety instructions and general
warnings.
These instruction manual is an integral part of the
OneGearDrive and also contains important service
information. Keep this instruction manual available with
the OneGearDrive at all times.
Compliance with the information in this instruction manual
is a prerequisite for:
•
Trouble-free operation.
•
Recognition of product liability claims.
Therefore, read this instruction manual before working on
or with the OneGearDrive.
VLT
®
is a registered trademark.
1.2 Document Version
This document is reviewed and updated regularly. All
suggestions for improvement are welcome.
Table 1.1 shows
the document version.
Edition Remarks
MG75C4xx Replaces MG75C3xx
Table 1.1 Document Version
1.3 Disclaimer
No liability is assumed for any damage or breakdown
resulting from:
•
Failure to observe the information in the
instruction manuals.
•
Unauthorized modifications to the OneGearDrive.
•
Operator error.
•
improper work on or with the OneGearDrive.
1.4 Product Overview
1.4.1 Intended Use
The OneGearDrive is intended for commercial installations,
unless otherwise expressly agreed. It complies with the
standards of the series EN 60034/DIN VDE 0530. Use in a
potentially explosive atmosphere is forbidden unless
expressly intended for this purpose. Increased safety
precautions (for example, protecting children from
inserting their fingers) are required in special cases, such as
use in non-commercial installations. Ensure these safety
conditions when setting up the installation. The
OneGearDrive is designed for ambient temperatures
between -4
°
F [-2
°
C] to 104
°
F [40
°
C] as well as for instal-
lation heights up to 3,300 ft [1000 m] above sea level. Any
deviations found on the nameplate must be considered.
Ensure that the conditions at the place of work correspond
to all the nameplate data.
Introduction Instruction Manual
4 Danfoss A/S © 08/2014 All rights reserved. MG75C422
1 1