Danfoss VLT Midi Drive FC 280, Operating Manual

Page: 27 / 82

130BC506.10
Setup 1
A
B
C
D
5
12
13 14 15
10
11
10
9
6
7
8
4
1
2
3
Menu
Status Quick
Menu
Main
Menu
Hand
On
Off
Reset
Auto
On
Back
OK
On
Warn
Alarm
Illustration 5.1 View of the NLCP
A. Numeric display
The LCD display is backlit with 1 numeric line. All data is
shown in the NLCP.
1
The set-up number shows the active set-up and the edit
set-up. If the same set-up acts as both active and edit set-
up, only that set-up number is shown (factory setting).
When active and edit set-up differ, both numbers are
shown in the display (for example set-up 12). The number
flashing indicates the edit set-up.
2 Parameter number.
3 Parameter value.
4
Motor direction is shown at the bottom left of the display.
A small arrow indicates the direction.
5
The triangle indicates whether the LCP is in Status, Quick
Menu, or Main Menu.
Table 5.1 Legend to Illustration 5.1 , Section A
130BD135.10
Setup 1234
INDEX
AHP
VkW
srpm
Hz%
n2 n1 n3
p5 p4
p3 p2 p1
Illustration 5.2 Display Information
B. Menu key
To select between Status, Quick Menu, or Main Menu,
press [Menu].
C. Indicator lights (LEDs) and navigation keys
Indicator Light Function
6 On Green
ON turns on when the frequency
converter receives power from the
mains voltage, a DC bus terminal, or a
24 V external supply.
7 Warn Yellow
When warning conditions are met, the
yellow WARN LED turns on, and text
appears in the display area identifying
the problem.
8 Alarm Red
A fault condition causes the red alarm
LED to flash and an alarm text is
shown.
Table 5.2 Legend to Illustration 5.1 , Indicator Lights (LEDs)
Key Function
9 [Back]
For moving to the previous step or layer
in the navigation structure.
10 [
▲
] [
▼
]
For switching between parameter groups,
parameters, and within parameters, or
increasing/decreasing parameter values.
Arrows can also be used for setting local
reference.
11 [OK]
Press to access parameter groups or to
enable a selection.
12 [
►
]
Press to move from left to right within
the parameter value to change each digit
individually.
Table 5.3 Legend to Illustration 5.1 , Navigation Keys
Commissioning Operating Guide
MG07A402 Danfoss A/S © 10/2017 All rights reserved. 25
5 5