Danfoss VLT HVAC Series, Programming Manual, Page: 111 / 338

NOTE!
Values for setting the minimum reference is found in open-loop par.3-02 Minimum Reference and for closed-loop par.20-13 Minimum Reference/
Feedb. - values for maximum reference for open-loop is found in par.3-03 Maximum Reference and for closed-loop par.20-14 Maximum Reference/
Feedb. .
6-51 Terminal 42 Output Min Scale
Range: Function:
0.00 %* [0.00 - 200.00 %] Scale for the minimum output (0 or 4 mA) of the analog signal at terminal 42.
Set the value to be the
percentage of the full range of the variable selected in par.6-50
Terminal
42 Output
.
6-52 Terminal 42 Output Max Scale
Range: Function:
100.00 %* [0.00 - 200.00 %] Scale for the maximum output (20 mA) of the analog signal at terminal 42.
Set the value to be the percentage of the full range of the variable selected in par.6-50
Terminal 42
Output .
It is possible to get a value lower than 20 mA at full scale by programming values >100% by using
a formula as follows:
20
mA
/
desired maximum current
× 100 %
i . e . 10 mA : 20
mA
10
mA
× 100 % = 200 %
VLT ® HVAC Drive Programming Guide 3 Parameter Description
MG.11.C6.22 - VLT ® is a registered Danfoss trademark
3-87
3