Compatible software versions:
•
VLT® HVAC Drive FC 102: 5.10
•
VLT® Refrigeration Drive FC 103: 2.10
•
VLT® AQUA Drive FC 202: 3.10
•
VLT® AutomationDrive FC 301/FC 302 and VLT® Lift Drive LD 302: 8.03
1.3 Approvals and Certifications
FCC ID: 2ANSELCP-103
NOTICE
FCC COMPLIANCE NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 1 or more
of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and the receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/television technician for help.
-
Modifications: Any modifications made to this device that are not approved by Danfoss may void the authority granted to
the user by the FCC to operate this equipment. RF EXPOSURE COMPLIANCE This portable transmitter with its antenna has
shown compliance with FCC’s SAR limits for general population/uncontrolled exposure. The maximum listed SAR level is
0.22 W/kg (body). The antenna used for this device must not be co-located or operating along with any other antenna or
transmitter.
Introduction
Installation Guide | VLT® Wireless Communication Panel LCP 103
AN331428064824en-000101 / 130R0814
2 | Danfoss A/S © 2020.02
