4.8 Main Menu - Communications and
Options - Group 8
4.8.1 8-0* General Settings
8-01 Control Site
Option:
Function:
This parameter overrules settings in
parameter 8-50 Coasting Select
to
parameter 8-56 Preset Reference Select
.
[0]
*
Digital and
ctrl.word
Control by using both digital input and
control word.
[1]
Digital only
Control by using digital inputs only.
[2]
Controlword
only
Control by using control word only.
8-02 Control Source
Option:
Function:
NOTICE
This parameter cannot be adjusted while
the motor is running.
Select the source of the control word.
[0] None
[1] FC Port
[3] Option A PROFIBUS and PROFINET.
8-03 Control Timeout Time
Range:
Function:
1 s
*
[0.1 -
6000 s]
Enter the maximum time expected to pass
between the reception of 2 consecutive
telegrams. If this time is exceeded, it indicates
that the serial communication has stopped. The
function selected in
parameter 8-04 Control
Timeout Function
Control Timeout Function
is
carried out.
8-04 Control Timeout Function
Option:
Function:
Select the timeout function. The timeout
function is activated when the control
word fails to be updated within the time
period specified in
parameter 8-03 Control
Timeout Time
. Option
[20] N2 Override
Release
only appears after setting the
Metasys N2 protocol.
[0]
*
Off
[1]
Freeze output
[2]
Stop
[3]
Jogging
[4]
Max. speed
[5]
Stop and trip
8-04 Control Timeout Function
Option:
Function:
[20] N2 Override
Release
8-07 Diagnosis Trigger
Option:
Function:
Select
[0] Disable
to send no extended
diagnosis data (EDD). Select
[1] Trigger on
alarms
to send EDD upon alarms or
[2]
Trigger alarm/warn.
to send EDD upon alarms
or warnings. Not all fieldbusses support the
diagnosis functions.
[0]
*
Disable
[1]
Trigger on
alarms
[2]
Trigger
alarm/warn.
4.8.2 8-1* Ctrl. Word Settings
8-10 Control Word Profile
Option:
Function:
Select the interpretation of the control
and status words corresponding to the
installed fieldbus. Only the selections valid
for the fieldbus installed in slot A are
visible in the LPC display.
[0]
*
FC profile
[1]
PROFIdrive
profile
8-14 Configurable Control Word CTW
Option:
Function:
[0]
None
The frequency converter ignores the
information in this bit.
[1]
*
Profile
default
The functionality of the bit is depending on
the selection
parameter 8-10 Control Word
Profile
.
[2]
CTW Valid,
active low
If set to 1, the frequency converter ignores
the remaining bits of the control word.
8-19 Product Code
Range:
Function:
Size
related
*
[0 -
2147483647]
Select 0 to readout the actual
fieldbus product code according
to the mounted fieldbus option.
Select 1 to readout the actual
vendor ID.
Parameters
Programming Guide
MG03N202
Danfoss A/S © 11/2015 All rights reserved.
71
4
4
Summary of Contents for VLT DriveMotor FCP 106
Page 2: ......
