Danfoss VLT AutomationDrive FC 300, Instruction Manual, Page: 6 / 98

2.7.1 Load Share Terminals 3-25
2.7.2 Regeneration Terminals 3-25
2.7.3 Anti-condensation Heater 3-25
2.7.4 Brake Chopper 3-25
2.7.5 line Power Shield 3-25
2.7.6 Line Power Disconnect 3-26
2.7.7 Contactor 3-26
2.7.8 Circuit Breaker 3-26
3 Startup and Commissioning
4-1
3.1 Pre-start 4-1
3.2 Applying Power 4-2
3.3 Basic Operational Programming 4-2
3.4 Local Control Test 4-4
3.5 System startup 4-4
4 User Interface
5-1
4.1 Local Control Panel 5-1
4.1.1 LCP Layout 5-1
4.1.2 Setting LCP Display Values 5-2
4.1.3 Display 5-2
4.1.4 Navigation Keys 5-3
4.1.5 Operation Keys 5-3
4.2 Back Up and Copying Parameter Settings 5-3
4.2.1 Uploading Data to the LCP 5-4
4.2.2 Downloading Data from the LCP 5-4
4.3 Restoring Default Settings 5-4
4.3.1 Recommended Initialization 5-4
4.3.2 Manual Initialization 5-4
5 Programming
6-1
5.1 Introduction 6-1
5.2 Programming Example 6-1
5.3 Control Terminal Programming Examples
6-3
5.4 International/North American Default Parameter Settings
6-3
5.5 Parameter Menu Structure
6-4
5.6 Remote Programming with MCT 10 Set-up Software
6-9
6 Application Examples
7-1
6.1 Introduction
7-1
Contents
VLT
®
Automation Drive D-Frame
Instruction Manual
MG34U222 - VLT
®
is a registered Danfoss trademark