Danfoss VLT 5042, Operating Instructions Manual

Page: 111 / 123

VLT® 5000 Crane
■
Additional Text
With this feature it is possible to read additional
text if bit 10, Additional text available , is true
in Basic characteristics.
To read out additional text, the parameter command
(PKE) must be set to F hex, see Databytes .
The index-field is used for pointing out which
element to be read. Valid indexes are in the range
of 1 through 254. The index must be calculated
after the following equation:
Index = Parameter value + 1 (see table below).
Value Index Text
0 1 English
1 2 Deutsch
2 3 Français
3 4 Dansk
4 5 Espanol
5 6 Italiano
Example:
In this example, the Master reads additional text
in parameter 001, Language . The telegram is
set up to read datavalue [0] which corresponds
to English . The following telegram must be sent
to the VLT frequency converter:
STX LGE ADR PKE IND PWE
HIGH
PWE
LOW
PCD1 PCD2 BCC
02 0E 01 F0 01 00 01 00 00 00 00 XX XX XX XX XX
STX = 02 Start byte
LGE = 0E Length of the remaining
telegram
ADR = Send the VLT frequency converter
on Address 1, Danfoss format
PKE = F001; F in the PKE field indicates
a
Read text and 01 indicates
parameter number 001, Language .
IND = 0001; 1 indicates that text to
parameter value [0] is required
The response from the VLT frequency converter will be:
STX LGE ADR PKE IND PVA PCD1 PCD2 BCC
02 11 01 F0 01 00 01 454E 474C 4953 48 XX XX XX XX XX
PKE = F001; F is the response for Text
transfer and 01 indicates parameter
number 001, Language .
IND = 0001; 1 indicates that index [1] is
sent
PVA = 45 4E 47 4C 49 53 48
E N G L I S H
The parameter value channel is now set up to a
visible string, which returns an ASCII character
for each letter in the index name.
MG.50.N4.02 - VLT is a registered Danfoss trademark
110