7.3 Options and Accessories
Danfoss offers a wide range of options and accessories for
the VLT
®
AutomationDrive FC 302. The following options
are installed on the control card in either slot A, slot B, or
slot C. Refer to
. For further information, see
the instructions that accompany the optional equipment.
130BC528.10
1
2
3
1
Slot A
2
Slot B
3
Slot C
Table 7.9
Illustration 7.3 Slot Options on the Control Card
VLT
®
General Purpose I/O MCB 101 is used for extension of
digital and analog inputs and outputs of FC 302. MCB 101
must be fitted into slot B in the VLT
®
AutomationDrive FC
302.
Contents:
•
MCB 101 option module.
•
Extended fixture for the LCP.
•
Terminal cover.
General Purpose I/O
SW. ver. XX.XX
MCB 101
FC Series
Code No. 130BXXXX
B slot
X30/
AIN4
7
8
6
5
4
3
2
1
9
10
11
12
AIN3
GND(2)
24V
AOUT2
DOUT4
DOUT3
GND(1)
DIN7
CO
M
DIN
DIN8
DIN9
130BA208.10
Illustration 7.4 MCB 101 Options Module
7.3.1 Galvanic Isolation in the VLT
®
General
Purpose I/O MCB 101
Digital/analog inputs are galvanically isolated from other
inputs/outputs on the MCB 101 and in the control card of
the frequency converter.
Digital/analog outputs in the MCB 101 are galvanically
isolated from other inputs/outputs on the MCB 101, but
not from the inputs/outputs on the control card of the
frequency converter.
Connect terminals 1 and 5 if the digital inputs 7, 8, or 9
are to be switched by use of the internal 24 V supply
(terminal 9). See
130BC526.11
1
2
3
4
5
6
7
8
9
10
11 12
COM DIN
DIN7
DIN8
DIN9
GND(1)
DOUT3
0/24 V
DC
DOUT4 0/24 V
DC
AOUT2 0/4-20 mA 24 V
GND(2)
AIN3
AIN4
RIN=
5k ohm
RIN=
10k ohm
-0 to +10
VDC
-0 to +10
VDC
0 V
24 V
0 V
24 V
24 V DC
0 V
0 V
24 V DC
<500 ohm
>600 ohm
>600 ohm
X30/
DIG IN
DIG &
ANALOG
OUT
ANALOG
IN
CPU
CAN BUS
CPU
Control card (FC 100/200/300)
General Purpose
I/O option MCB 101
PLC
(PNP)
PLC
(NPN)
Illustration 7.5 Principle Diagram
Ordering Information
VLT
®
Parallel Drive Modules
68
Danfoss A/S © 6/2016 All rights reserved.
MG37N102
7
7
Summary of Contents for VLT 380-500 V
Page 2: ......
