Danfoss Heating
15
GB
1.8.3 Programming in 24 hour mode
(Every day of the week uses the same programme)
a) Press the
PROG
button until event 1 fl ashes
(Fig. 16)
.
b) Amend the time and temperature as follows:
i)
Press
the
+
and
–
buttons to alter the time (press and hold to
move in 10 minute increments).
ii)
Use
the
V
or
Λ
buttons to alter the temperature in 0.5°C (1°F)
steps.
iii)
Press
the
NEXT
button to advance to the next event
(Fig.
17)
.
iv) Repeat the steps above for the remaining events.
c) When all events are programmed press the
PROG
button to
return to
RUN
mode
(Fig. 18)
.
1.8.4 Programming in A+B mode
(Installer setting 41 must be in 5+2 mode)
Press and hold the
PROG
and
V
buttons for 3 seconds.
The display will change to that shown in
Fig. 19
. This
will take you into
User Advanced Programming
Mode
option 1.
Use the
Λ
or
V
buttons to enable or disable the
function (1=enabled, 0=disabled).
Fig. 16
Fig. 17
Fig. 18
Fig. 19