AI097986404620en-010102 | 3
© Danfoss | 2022.05
Data sheet
REPI Series Digital Thermostat Manual
30
Override output value when bypass PID control
Display output value when enable PID control
0 - 255
31
Input signal management: 0: Input valid
1: Override Input: open
2: Override Input: close
0
0-2
32
Display room temperature or set-point
0: Room temperature 1: Set-Point
0
0-1
33
Configuration external sensor
0: B = 3950; 1: B = 3450; 2: B = 3900
3: User define (via network. default B = 3950)
0
0-3
34-38
N/A
39
Start temperature of Low temperature protection
5 °C/42 °F
0-15 °C/42-62 °F
1 °C/2 °F
40
Stop temperature of Low temperature protection
7 °C/46 °F
2-17 °C/46-66 °F
1 °C/2 °F
It will confirm itself 20 seconds later after setting and return to Off state.
Parameter table
(continuous)
Specification
There is a 5 poles switch on PCB. The meaning is below:
Location
ON
OFF
1
120 ohm Resistance between AB wires
No Resistance between AB wires
2
Port 1 Modulation 0 - 20mA
Off
3
Port 1 Modulation 0 - 10VDC
Off
4
Port 2 Modulation 0 - 20mA
Off
5
Port 3 Modulation 0 - 10VDC
Off
40
Stop temperature of Low temperature protection
7 °C/46 °F
Mounting
1. Open the back panel with screwdriver.
2. Connect the wires follow the diagram.
3. Fix the base with screw.
4. Fix the front panel and finish the installation.
