Serial communication is only capable of reading
parameters containing data type 9 (text string).
15-40 FC Type
to
15-53 Power Card Serial Number
contain
data type 9.
For example, read the unit size and mains voltage range in
15-40 FC Type
. When a text string is transferred (read), the
length of the telegram is variable, and the texts are of
different lengths. The telegram length is defined in the
second byte of the telegram (LGE). When using text
transfer, the index character indicates whether it is a read
or a write command.
To read a text via the PWE block, set the parameter
command (AK) to ’F’ Hex. The index character high-byte
must be “4”.
8.4.11 Data Types Supported by the
Frequency Converter
Unsigned means that there is no operational sign in the
telegram.
Data types
Description
3
Integer 16
4
Integer 32
5
Unsigned 8
6
Unsigned 16
7
Unsigned 32
9
Text string
8.4.12 Conversion
The various attributes of each parameter are displayed in
the section Factory Settings. Parameter values are
transferred as whole numbers only. Conversion factors are
therefore used to transfer decimals.
4-12 Motor Speed Low Limit [Hz]
has a conversion factor of
0.1.
To preset the minimum frequency to 10Hz, transfer the
value 100. A conversion factor of 0.1 means that the value
transferred is multiplied by 0.1. The value 100 is thus
perceived as 10.0.
Conversion index
Conversion factor
74
0.1
2
100
1
10
0
1
-1
0.1
-2
0.01
-3
0.001
-4
0.0001
-5
0.00001
8.4.13 Process Words (PCD)
The block of process words is divided into two blocks of
16 bits, which always occur in the defined sequence.
PCD 1
PCD 2
Control telegram (master
⇒
slave Control
word)
Reference-value
Control telegram (slave
⇒
master) Status
word
Present output
frequency
8.5 Examples
8.5.1 Writing a Parameter Value
Change
4-14 Motor Speed High Limit [Hz]
to 100Hz.
Write the data in EEPROM.
PKE = E19E Hex - Write single word in
4-14 Motor Speed
High Limit [Hz]
:
IND = 0000 Hex
PWEHIGH = 0000 Hex
PWELOW = 03E8 Hex
Data value 1000, corresponding to 100Hz, see
.
The telegram looks like this:
E19E H
PKE
IND
PWE
high
PWE
low
0000 H 0000 H 03E8 H
130BA092.10
Note:
4-14 Motor Speed High Limit [Hz]
is a single word, and
the parameter command for write in EEPROM is “E”.
Parameter number 4-14 is 19E in hexadecimal.
The response from the slave to the master is:
RS485 Installation and Set-...
VLT Micro Drive Design Guide
74
MG02K102 - VLT
®
is a registered Danfoss trademark
8
8