7
VISGZ45X © Danfoss 04/2011
Installation Guide
Danfoss Link™ FT
Installation
Operation mode
Danfoss Link™ FT supports two types of operation modes:
1 .
ON/OFF switching:
do not connect a floor sensor with
Danfoss Link™ FT in this modus .
2 .
Heating regulation:
when installing the Danfoss Link™ FT
you have to consider the type of heating and thus which
sensors should be used .
There are three options:
1 .
Comfort heating:
Constant temperature on the floor in
bathrooms and other rooms where a comfortable warm
surface is required . Install the Floor sensor and choose Floor
regulation for the room when doing the configuration .
2 .
Total heating:
Control of room temperature in living rooms
etc . Install the floor sensor and a Danfoss Link™ RS . Choose
Combined regulation when doing the configuration on the
Danfoss Link™ CC .
3 .
No floor sensor:
A floor sensor is not present, and cannot
be installed . You must install a Danfoss Link™ RS . Choose
Room regulation .
Be aware that temperature control is less accurate without a
floor sensor and that all Danfoss Link™ FT in a room need to
have the same sensor configuration .
Danfoss recommends always installing a floor sensor .
Note! Do not install electric floor heating system without a floor
sensor, when the heating element is installed on or beneath
wooden surfaces and other surfaces sensitive to temperature!
GB