Danfoss ET9650, Operator'S Manual

Page: 36 / 64

5.4 Stop
1. Complete the cutting process.
2. Deposit the work piece outside the machine.
3. Deactivate the main switch (1).
4. Check the machine for glowing embers.
5. Check the machine for contamination and outside damage.
6. Check the cutting knife for damage and cracks.
7. Remove contamination, dust and chips using a vacuum.
Inform the fitter in case of damage or other irregularities.
5.5 Overload protection
The motor is protected against overload by a motor protection switch.
After a motor overload, if any, let the motor cool down and restart it.
The restart protection prevents an unintentional restart of the ma-
chine. Starting the machine is only possible by activating the main
power switch again.