Danfoss ET6100, Operator'S Manual

Page: 32 / 56

7. Tighten the threaded pin using the Allen wrench (3).
8. Close the protection cover.
5.6.2 Adjusting the outside skiving length and outside skiving diameter
1. Deactivate the machine on the power switch and secure it
against unintentional restart.
2. Open the protection cover.
WARNING!
Cutting risk!
There is an acute risk of injuries to the hands when the skiving
knives are replaced.
• Always wear protective gloves when changing the skiving
knives.
3. Turn the rotating handle (5) to set the cutting arm (4) to the re-
quired position. The value can be read on the adjusting scale
(6).
4. Loosen the hexagon socket cylinder bolts (3) but do not remove
them.
5. Adjust the outside skiving knife (1) to set the required diameter.