•
Preferably form the workpiece in the centre of the crimping die
length. Eccentric forming will result in a conical forming result
and increased lopsided wear on the die system and the bearing
plates.
5.3.2 Operation mode buttons control panel
WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the die and the workpiece.
• Keep the feed opening for the workpiece as small as possi-
ble.
• Keep a minimum distance of 120 mm (A) to the die system.
1.
Manually position the pre-mounted workpiece in the tool.
2.
Hold the workpiece with one hand during the forming process.
3.
Press and hold the button [
] to close the tool; the forming pro-
cess starts and ends when the pre-set diameter/pressure is
reached.
4.
Press the [
] button upon completion of the forming process to
open the tool.
5.
Remove the workpiece from the tool.
Summary of Contents for ET4350
