Danfoss ET4100, Operator'S Manual

Page: 40 / 60

3. Loosen bolts (1) on bearing plate (2).
4. Remove the worn bearing plate (2).
5. Insert the new bearing plate (2).
Replace all eight bearing plates in this manner.
6. Tighten screws (1).
Shims, if present, have to be inserted at the same position as be-
fore.
Check the machine zero point after each bearing plate replace-
ment and readjust the micrometre if necessary.
The bearing plate on the front plate can only be
replaced by the UNIFLEX Service.
6.5 Micrometer adjustment
If the measured forming dimensions of the workpiece deviate from
the forming dimensions of the crimping die when the micrometer is
set to zero, the micrometer must be readjusted.
1. Release the screws on the cover.
2.
Remove the cover (see “Annex” in Section 9).
3. Loosen the counter-nut (1) of the contact screw (2).