Danfoss E3h Installation Instructions Download

Page: 2 / 4

Installation Instructions

Removing the Top Fan

To remove and replace the top fan, use the following procedures. Refer to

Remove 2 screws (T25) from the fan housing.

Slide the fan housing and fans out from under the retaining clips.

Unplug the in-line connector attaching the fan cable.

Feed the cable through the cable access hole.

Lift the fans from the pins in the fan housing.

Installing the Top Fan

Place the fans over the pins in the fan housing. Check that the air direction arrows point upward and away from the drive.

Feed the fan cables through the cable access hole on the top plate.

Reconnect the in-line cable connector.

Slide the fan housing and fans into position under the retaining clips.

Secure 2 screws (T25) in the fan housing.

Fan housing

Screw (T25)

Mounting pin (inside housing)

Cable access hole

Fan

Retaining clip

Illustration 1.1 Top Fan

Installation Instructions

Top Fan Replacement for E3h/E4h Drives

MI35N102

Summary of Contents for E3h

Page 1: ...njury or equipment failure Only use qualified electricians for the installation Disconnect the drive from all power sources before installation or service Treat the drive as live whenever the mains vo...

Page 2: ...lling the Top Fan 1 Place the fans over the pins in the fan housing Check that the air direction arrows point upward and away from the drive 2 Feed the fan cables through the cable access hole on the...

Page 4: ...ucts already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed All trademarks in this material are property of the resp...