3
ED.95.R9.02
© Danfoss 03/2014
DEN-SMT/SI
230V
Data sheet
Actuators for three point control AMV 25, AMV 35
Wiring
230 Vac version:
Do not touch anything on
the PCB! Lethal voltage!
Terminals 1, 3:
Control voltage input from the controller.
Power supply 24 V~, 230 V~ (dependent on type)
Terminals 4, 5:
Output used for position indication or
monitoring.
N
Neutral/Common (0 V)
Additional switches (2
×
)
Additional switches (2
×
) and potentiometer
Accessories
Commissioning
Complete the mechanical and electrical
installation and perform the necessary checks
and tests:
- Turn on the power.
- Set the appropriate control signal and
check that the valve stem direction is correct
for the application.
The unit is now fully commissioned.
Manual override
The manual override is achieved by turning the
manual knob to the required position.
Observe the direction of rotation symbol.
• Disconnect control signals
• Press rubber button
• Adjust valve position using the control knob
• Set valve to closed position
• Restore control signals.