VD.CV.A2.02
4 | © Danfoss | DHS-SRMT/SI | 2016.09
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alterations can be made without subsequential changes being necessary
eady agreed.
All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
AME 55 QM + AB-QM DN 125
AME 55 QM + AB-QM DN 150
Data sheet
Actuator for modulating control AME 55 QM
Actuator - valve
combinations
The manual override is applied by rotating the
4 mm Allen key (not supplied) to the required
position. Observe the direction of the rotation
symbol.
• Disconnect power supply
• Adjust valve position using an Allen key
• Set valve to closed position
• Restore power supply
If manual override has been used then X and Y
signal are not correct until the actuator reaches
its end position. If this is not accepted reset the
actuator, or apply accessory active return signal
kit.
Dimensions
Manual override
120
32
8
m
in
47
8
55
