Danfoss AHF 005, Manual

Page: 4 / 22

AHF 005/010
■
Ordering numbers, 380 - 415 V, 50 Hz
AHF 005 and AHF 010, 380V - 415V, 50Hz
Danfoss ordering number Typical Danfoss adjustable frequency drive series I
AHF,N
Typical Motor
Used [kW]
AHF 005 AHF 010 VLT 5000 VLT 6000 HVAC VLT 8000 AQUA
10 A 4, 5.5 175G6600 175G6622 5006, 5008 6006, 6008 8006, 8008
19 A 7.5 175G6601 175G6623 5011 6011 8011
26 A 11 175G6602 175G6624 5016 6016 8016
35 A 15, 18.5 175G6603 175G6625 5022, 5027 6022, 6027 8022, 8027
43 A 22 175G6604 175G6626 5032 6032 8032
72 A 30, 37 175G6605 175G6627 5042, 5052 6042, 6052 8042, 8052
101 A 45, 55 175G6606 175G6628 5062, 5072 6062, 6072 8062, 8072
144 A 75 175G6607 175G6629 5102 6102 8102
180 A 90 175G6608 175G6630 5122 6122 8122
217 A 110 175G6609 175G6631 5152 6152 8152
289 A 132, 160 175G6610 175G6632 5202, 5252 6172, 6222 8202, 8252
324 A 175G6611 175G6633
370 A 200 175G6688 175G6691 5302 6272 8302
Higher ratings can be achieved by paralleling the filter units
434 A 250 Two 217A units 5352 6352 8352
578 A 315 Two 289 A units 5452 6402 8452
613 A 355 289 A and 324 A units 5502 6502 8502
648 A 400 Two 324 A units 6552 8602
Please note that the matching of the typical Danfoss adjustable frequency drive and filter is pre-calculated
based on 400V and assuming typical motor load (4- or 2-pole motor). VLT 5000 series is based on a max.
160 % torque application, while VLT 6000 and 8000 series are based on a max. 110% torque application.
The pre-calculated filter current may be different than the input current ratings of the VLT 5000, VLT 6000,
and VLT 8000 series as stated in the respective instruction manuals, as these numbers are based on
different operating conditions.
MG.80.B4.22 - VLT is a registered Danfoss trademark
4