Danfoss ADAP-KOOL Drive, Programming Manual, Page: 32 / 262

0-02 Motor Speed Unit
Option: Function:
This parameter cannot be adjusted while the motor is running.
The display showing depends on settings in par.0-02
Motor Speed Unit and par.0-03 Regional Set-
tings . The default setting of par.0-02 Motor Speed Unit and par.0-03 Regional Settings depends on
which region of the world the frequency converter is supplied to, but can be re-programmed as
required.
NB!
Changing the
Motor Speed Unit
will reset certain parameters to their initial value.
It is recommended to select the motor speed unit first, before modifying other
parameters.
[0] RPM Selects display of motor speed variables and parameters (i.e. references, feedbacks and limits) in
terms of motor speed (RPM).
[1] * Hz Selects display of motor speed variables and parameters (i.e. references, feedbacks and limits) in
terms of output frequency to the motor (Hz).
0-03 Regional Settings
Option: Function:
This parameter cannot be adjusted while the motor is running.
The display showing depends on settings in par.0-02
Motor Speed Unit
and par.0-03
Regional Set-
tings
. The default setting of par.0-02
Motor Speed Unit
and par.0-03
Regional Settings
depends on
which region of the world the frequency converter is supplied to but can be re-programmed as
required.
[0] * International Sets par.1-20 Motor Power [kW] units to [kW] and the default value of par.1-23 Motor Frequency
[50 Hz].
[1] North America Sets par.1-21
Motor Power [HP]
units to HP and the default value of par.1-23
Motor Frequency
to
60 Hz.
The setting not used is made invisible.
0-04 Operating State at Power-up
Option: Function:
Select the operating mode upon reconnection of the frequency converter to mains voltage after
power down when operating in Hand (local)mode.
[0] * Resume Resumes operation of the frequency converter maintaining the same local reference and the same
start/stop condition (applied by [Hand On]/[Off] on the LCP or Hand Start via a digital input as
before the frequency converter was powered down.
[1] Forced stop, ref=old Uses saved reference [1] to stop the frequency converter but at the same time retain in memory
the local speed reference prior to power down. After mains voltage is reconnected and after re-
ceiving a start command (using the LCP [Hand On] button or Hand Start command via a digital
input) the frequency converter restarts and operates at the retained speed reference.
0-05 Local Mode Unit
Option: Function:
Defines if the local reference unit should be displayed in terms of the motor shaft speed (in RPM/
Hz) or as percent.
[0] * As Motor Speed Unit
[1] %
3 Parameter Description ADAP-KOOL ® Drive Programming Guide
32
MG.11.N1.02 - VLT ® is a registered Danfoss trademark
3