Danfoss 176F4057, Installation Manual

Page: 5 / 14

1.
2.
3.
4.
1 Cabinet
2 Bottom gasket
3 Bottom cover
4 M5x14 screw
5 Top cover
6 Top gasket
7 Clip-on nut
8 Back duct
9 M5x18 screw
10 6-hole gasket
11 8-hole gasket
12 M6x12 screw
2.3 Creating Vent Openings in the Mounting Plate
To create upper and lower vent openings in the mounting plate, use the following steps. Use the dimensions in Illustration 3 for 600
mm (24 in) cabinets, and Illustration 4 for 800 mm (32 in) cabinets.
Procedure
Drill 6 mounting holes in the back of the frequency converter using the dimensions in the template.
Insert 6 M10 pem self-clinching nuts (not supplied) in the mounting holes.
Cut out the upper and lower vent openings in the mounting plate using the dimensions in the template.
The openings must match the frequency converter vent openings.
Drill 6 screw holes around each vent opening using the dimensions in the template.
The holes must match the holes in the frequency converter and the inner flange of the back ducts.
AN361428862578en-000101 / 136R0249 | 5 Danfoss A/S © 2022.03
Installation
In-back/Out-back Cooling Kit for FA11-FA12
Installation Guide