Set-up
1.
Perform set-up according to
.
2.
Use the [+]/[-] keys to set reference.
3.
At power-up, the unit is always in stop mode. The set reference is stored during power down. To set up permanent start
mode, connect terminal 12 to terminal 19 and do not connect purple/gray wire to terminal 12. Permanent start mode
disables the stop function on the LOP.
Function
Settings
Key I (Start)
Key II (Start)
Key (Stop)
Default - Dual speed operation
(connect purple or orange wire)
No changes to factory setting.
Run on set
reference (+/-)
Run on 5 Hz
1)
jog speed
Stop (and reset
2)
- if trip)
Function 2 - Dual-mode
operation
(connect purple or orange wire)
Select the modes of operation in set-ups 1 and 2.
Set
parameter 0-10 Active Set-up
to
[9] Multi Set-up
.
Set
parameter 5-13 Terminal 29 Digital Input
to
[23] Set-up
select bit 0
.
Run with
set-up 1
Run with
set-up 2
Stop (and reset
2)
- if trip)
Function 3 - Dual direction
operation (connect gray wire)
Set
parameter 4-10 Motor Speed Direction
to
[2] Both
directions
.
Set
parameter 5-13 Terminal 29 Digital Input
to
[11] Start
reversing
.
Run forward
Run reverse
Stop (and reset
2)
- if trip)
Table 1.3 LOP Operation Mode
1) Set jog speed in parameter 3-11 Jog Speed [Hz]
2) When reset is required, set parameter 5-11 Terminal 19 Digital Input to [1] Reset.
Installation Instructions
LOP Connection and Set-up
VLT
®
DriveMotor FCP/FCM 106
MI03L202
Danfoss A/S © 09/2015 All rights reserved.
3
