User Guide
|
Intelligent Purging System (IPS 8) for Ammonia - Technical data, installation and use
© Danfoss | DCS (ms) | 2020.01
BC306932151284en-000201 | 3
Legal notice
This product information is a part of the documentation for the Danfoss scope of delivery and serves
as product presentation and customer advisory service. It contains important information and
technical data regarding the product.
This product information should be supplemented with the information about the industrial safety
and health related regulations at the site of installation of the product. The regulations vary from
place to place as a result of the statutory regulations applicable at the site of installation and are
therefore not considered in this product information.
In addition to this product information and the accident prevention regulations applicable for the
respective country and area where the product is used, the technical regulations for safe and
professional work must also be observed.
This product information has been written in good faith. However, Danfoss cannot be held responsible
for any errors that this document may contain or for their consequences.
Danfoss reserves the right to make technical changes during the course of further development of the
equipment covered by this product information.
Illustrations and drawings in this product information are simplified representations. As a result of
the improvements and changes, it is possible that the illustrations do not exactly match the current
development status. The technical data and dimensions are subject to change. No claims will be
accepted on the basis of them.
Date: YYYY.MM.DD
Place of issue:
Issued by
Date: YYYY.MM.DD
Place of issue:
Approved by
Signature:
Name: Su Cheong Ho
Title: Lead Design Engineer
Signature:
Name: Behzad Parastar
Title: Product Manager
Danfoss only vouches for the correctness of the English version of this declaration. In the event of the declaration being translated into any other
language, the translator concerned shall be liable for the correctness of the translation
ID No:
084R9456
This doc. is managed by 500B0577
Revision No:
AA
Page
1 of
Danfoss A/S
6430 Nordborg
Denmark
CVR nr.: 20 16 57 15
Telephone: +45 7488 2222
Fax: +45 7449 0949
EU DECLARATION OF CONFORMITY
Danfoss A/S
Refrigeration & Air Conditioning Controls
declares under our sole responsibility that the
Product category:
Intelligent Purger System (Air Purger)
Type designation(s):
IPS 8
Covered by this declaration is in conformity with the following directive(s), standard(s) or other normative
document(s), provided that the product is used in accordance with our instructions.
Machine Directive 2006/42/EC
EN 378-2:2016 Refrigerating systems and heat pumps - Safety and environmental requirements - Part 2: Design,
construction, testing, marking and documentation
IEC 60204-1:2018 Safety requirements for electrical equipment for measurement, control and laboratory use - Part 1:
General requirements
Pressure Equipment Directive 2014/68/EU (PED)
EN 378-2:2016 Refrigerating systems and heat pumps - Safety and environmental requirements - Part 2: Design,
construction, testing, marking and documentation
Ammonia side (R717): Category A4P3. Fluid group: 1. PS = 40 bar. TS: -40
C to 60
C
R452A side: Category 1. Fluid group: 2. PS = 28 bar. TS: -40
C to 60
C
Ambient temperature: -10
C to 43
C
Electromagnetic Compatibility Directive 2014/30/EU (EMC)
IEC 61000-6-2 Electromagnetic compatibility (EMC) - Part 6-2: Generic standards - Immunity standard for industrial
environments (IEC77/488/CDV:2015)
EN 61000-6-4 Electromagnetic compatibiliy (EMC) - Part 6-4: Generic standards - Emission standard for industrial
environments
Note: EMC test performed with cable length < 30m.
1
