D&R PUBMATE, Manual

Page: 14 / 25

SETTING UP AN INPUT CHANNEL
- Depress the PFL switch in a channel that is connected to a source.
- Listen via the PFL switch in your headphones if there indeed is a signal.
- Now slowly push up the corresponding fader up to position 8.
- Now you will notice the green LED glowing and if the input level is sufficient the LED will occasionally flash
red.
- Now you can turn up the master volume to about the level you need.
- You can change the input sound by adjusting the master equalizer-section according to your needs.
- The peak LED is an indication of the level that enters the console. It is calibrated to in4dBu when
the LED is green with occasionally being red.
- Release the PFL switch and you hear the same signal in stereo in your headphones.
- The other inputs are likewise adjusted, using the "PFL" switches to pre fade listen to connected sources.
NOTE:
Be carefully not to place the Pubmate near heavy power transformers, as used in power amps etc, this may
couse hum, inspite of the metal case.
WIRING SUMMARY OF ALL CONNECTORS
MIC input XLR connector balanced input impedance 2 kOhm.
pin 2-in faze.
pin 3-out of phase.
pin 1 -ground
sensitivity - 60 dBu.
LINE input Cinch (tulp) connectors for left and right.
Sensitivity: 0dBu (775mV0
PHONO inputs (with activated R.I.A.A. correction amp only
47 kOhm 5 mv
MASTER OUTPUTS XLR male connector for left and right.
pin 2-in phase.
pin 3-ground compensated.
pin 1 -ground.
output level +4 dBu (1.23volt)/100 Ohm .
Cinch connector for both left and right.
output level +4 dBu (1.23volt)/100 Ohm .
shielding is ground.
TAPE Cinch connector for both left and right.
-10dBv (300mv) uitgang / 1kOhm.
shielding is ground.
PHONES Stereo power amp. Do not load below 16 ohm.
Pubmate manual page: 13