AUX RETURN
This stereo input is intended to be used for returning reverbs. This input is directly
connected to the stereo main mix buss and can be used to connect other mixers without
loosing valuable input channels.
CUE AUX RETURN
This switch enables you to stereo pre listen to an incoming Aux return signal.
BALANCE
The balance knob controls the balance between the main stereo output and the stereo Cue
signal when selected.
Note: The split switch de-activates the balance control.
With the balance control anywhere between Cue and L/R you always have control over the
main output signal even when a Cue switch is activated.
SPLIT
When the split function is activated the following listening situation is created.
The left side of the phones output gives the summed Cue signal and the right output gives the
summed left/right signal (pre fader).
The balance control has no influence on this configuration anymore.
PHONES
The phones output (located on the frontpanel) has an automatic input selector.
Normally the left/right output is heard until a Cue switch is activated anywhere in the console
that inmediately takes over the left/right signal. The ledbar switches accordingly with this
action. We advice you to use headphones with an input impedance not lower than 400 Ohm
to avoid distortion. An 8 Ohm headphone will produce lots of distortion when cranking up
the level due to its low impedance load. It is a load equivalent to the load that loudspeakers
normally present to power amps and as you know the Discom 4 is no power-amp, sorry.
MASTER FADER
The Discom 4 master fader is a 51mm model controlling both left and right signals at the same
time.
MASTER CONNECTORS
The master connector panel houses 12 Cinch connectors and 2 male XLR connectors where
all interfacing takes place.
Furthermore the mains connector with
integrated fuse holder is located in this
section. A ground terminal completes the
back panel connector section.
TAPE OUTPUTS
The first connectors on the left are the
tape output connectors. Both left and
right connectors are paralelled for
connecting more than one tapedeck or
DAT recorder.
Output level is -10dBv (300mV).
Discom 4 manual page: 20
Summary of Contents for DISCOM 4
Page 1: ... DISCOM 4 MANUAL ...
