MAINTENANCE:
Keep Lokk-Bolt rod clean. Lubricate the Lokk-Bolt using only graphite powder. DO NOT use oil or grease.
WARRANTY & LIMITATION OF LIABILITY
D&D Technologies’ (“D&D”) products are warranted to be free of defects in materials and workmanship to the original purchaser for
as long as he/she owns the product. This product will operate properly, and warranty is valid, only if installed in accordance with the
instructions and specifications shown. If a structural defect appears, the original purchaser may return the item, freight prepaid, to-
gether with proof of purchase to D&D or its approved international agents. D&D or its agent will, at their discretion, repair or replace
the defective item or part without charge to the purchaser. THIS WARRANTY SHALL NOT APPLY WHEN the product has been tampered
with, when repairs or attempted repairs have been made by unauthorized persons, where the item has been subjected to misuse,
abuse, accident or damage in transit, or where the installer has not followed the instructions set out during installation, operations, or
Maintenance Requirements. IN NO EVENT SHALL THE COMPANY BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES. No
warranty is given other than that set out above. No other express or implied warranties (including statutory warranties) apply, other
than warranties which may not be legally excluded.
FITTING INSTRUCTIONS CONTINUED…
©
Copyright 2002 D&D Group P/L Sydney, Australia
Patents, Trademarks, Registered Designs apply worldwide
DB000000018PA •Inst_LokkBolt (10/1/07)
Re-configuring the Lokk-Bolt for Left-Hand Gates
1) Drive the Pin out of the lower end of the stainless steel rod.
Place the Pin in a safe place.
2) Slide the Lower and Upper Brackets off the rod…BUT
remember which of the brackets is the Upper Bracket.
3) Flip over the two Brackets (i.e. rotate them end over end)
and slide them back onto the rod – ensuring that the Upper
Bracket slides onto the rod first (as it carries a detent clip within
its housing). The Upper Bracket will meet resistance when it
reaches each of the detent grooves on the rod; simply push it
through the first groove and into the second (upper) groove.
4) Insert the Pin back into the end of the rod. Ensure at least
1/16” (nearly 2mm) of the pin is left protruding to prevent the
Brackets sliding off the bolt.
9"
(230mm)
Maximum
3.1/8"
(80mm)
Maximum
21"
(530mm)
Maximum
18"
model
24"
model
36"
model
DIAGRAM B
When the two Brackets
(left) have been
removed, flipped and
re-inserted onto the
rod, the Side-Fixing
Legs will go from
being on the left-hand
side of the Lokk-Bolt
to the right-hand side.
Side-Fixing
Legs
Side-Fixing
Legs
UPPER
BRACKET
Upper
Bracket
www.ddtechglobal.com
USA:
7731 Woodwind Drive, Huntington Beach, CA 92647
AUSTRALIA:
U6, 4-6 Aquatic Drive, Frenchs Forest NSW 2086
EUROPE:
Vondellaan 58, 3521 GH Utrecht, Pays-Bas
DIAGRAM C
