Z5786 XSL Stack adapter
1.5 Assembly/Disassembly
Attaching the adapter
The adapter is attached to the rear rigging strand of the SUB
cabinet. To attach the adapter, proceed as follows:
1. Release the two Locking pins on the rear rigging strand of the
SUB cabinet.
2. Attach the adapter as shown in the graphic opposite.
3. Reinsert and lock the two Locking pins on the SUB cabinet.
Adjusting the sliding carriage
1. Release the Locking pin of the bottom hole grid on the sliding
carriage.
2. Move the sliding carriage until the hole of the bottom hole grid
that corresponds to the desired tilt angle is in line with the
fixed hole of the rail.
3. Reinsert and lock the bottom Locking pin to this hole to fix the
sliding carriage in place.
Attaching the first cabinet
1. On the SUB cabinet, release the upper Locking pins on both
sides.
↳The Front link extends automatically.
2. Attach the first cabinet until the Front links of the SUB cabinet
fit into the slots at the front of the TOP cabinet.
3. Insert and lock the Locking pins of the SUB cabinet's Front links
on both sides.
4. At the rear, release the Splay link of the TOP cabinet.
5. Ensure Locking pin
[3] is inserted in the Tension mode hole at
the bottom of the rigging strand (
Þ
Red labeled hole -
).
6. Insert the Splay link into the sliding carriage of the Stack
adapter and reinsert the Locking pin into the corresponding
hole to fix the Splay link in place.
*Shown:
Sliding carriage position for –6° downtilt
d&b Z5786 Rigging manual 1.1 en
6
