d&b audiotechnik Z5576.000, Manual

Page: 14 / 22

5.2. I/O panel
For systems not using Dante audio, inputs and input links can be
directly connected to the I/O panel
5.2.1. INPUT section
The INPUT section represents the input connectors of the first
amplifier while the other amplifiers are linked within the rack. The
INPUT section allows both analog and digital audio signals to be
fed to the amplifier.
5.2.2. INPUT LINK section
The INPUT LINK section represents the link output connectors of the
last amplifier and allows the linking of further system racks using
the enclosed rack link cable (Z5333 Rack link).
5.2.3. REMOTE section
The REMOTE section allows the daisy chaining of rack assemblies
within a remote network using the enclosed rack link cable (Z5333
Rack Link).
For detailed specifications, please refer to the following sections:
Þ
Ethernet network
Þ
CAN-Bus network
I/O panel, rack link example:
2ch Analog audio and Ethernet/OCA
DS10 mode: Red VLAN
Ethernet network
For remote purposes via Ethernet/OCA, it is strongly
recommended to use the prewired configuration in combination
with the DS10 when linking entire rack assemblies, as shown in the
graphic opposite.
It is recommended to link a maximum of up to 6 rack assemblies in
this way.
Do not link/daisy chain entire rack assemblies using the ETH 1/
ETH 2 connector sockets of the I/O panel.
d&b Z5576.000 Manual 1.1 en 14