A-Series rigging components
2.3.4 Splay link of the Base plate
The rear rigging slot of the Base plate is also equipped with a
Splay link. Depending on its position in the hole grid of the rigging
slot and on its set length (Standard or Extended), the Splay link
allows either an uptilt or a downtilt of the first cabinet.
Up
In combination with the 35° hole on the rear rigging
strand of the first cabinet and with the Splay link set to
'Standard' length, the rigging slot of the Base plate
allows for uptilt angles of 5° (upper hole), 10° (center
hole) and 15° (bottom hole).
Down
In combination with the 20° hole on the rear rigging
strand of the first cabinet and with the Splay link set to
'Extended' length, the rigging slot of the Base plate
allows for downtilt angles of –10° (upper hole), –5°
(center hole) and 00° (bottom hole), shown as an
example in the graphic opposite.
The splay angle(s) of the next (two) cabinet(s) is/are set in the
same manner as described in the previous sections.
Changing the Splay link position
To easily change the position of the Splay link of the Base plate, it
is fixed using the corresponding Locking pin.
To change the position of the Splay link, proceed as follows:
1. Release the Locking pin.
2. Move the Splay link to the desired hole position in the rigging
slot.
3. Insert the Locking pin and ensure the pin is fully inserted and
properly locked.
d&b Z5458
AL Base plate Rigging manual 1.1 en
9
