An additional 12 mm (0.47") hole is provided on the mounting
plate as a feed-through for the connection cable.
Ball joint adapter
The ball joint adapter of the wall mount is equipped with a set
screw. It is used to preset the clamping of the ball joint.
If necessary, adjust the set screw using the 3 mm Allen hex key.
Attaching the ball joint to the cabinet
NOTICE!
–
Only use the supplied and specified screws
[3], otherwise
there a risk of damaging the threaded inserts.
–
Always use the spring washers
[4] to prevent the bolts from
slackening.
1. Attach the wall mount to the two M8 threaded inserts on the
rear panel of the cabinet.
2. Insert the screws together with the U and spring washers and
tighten them using the spanner (#13).
Alternatively, one screw may be replaced by the supplied
eyebolt
[5] to allow the attachment of a secondary safety
wire.
Attaching the assembly to the mounting plate
To attach the assembly to the mounting plate, proceed as follows:
1. Slacken the fixing screw
[F] and the set screw [S] to release
the M10 socket
[I] of the ball joint.
2. Attach the assembly and bolt down the threaded insert to the
mounting plate.
3. Tighten the M10 socket using the spanner (#17).
4. Set the desired angle of the cabinet and adjust the set screw
[S].
5. Finally tighten the fixing screw
[F].
d&b Z5401 Wall mount S, Mounting instructions (1.2 EN)
6
