Altering the HF horn dispersion
Depending on the application (horizontal or vertical setup of the
cabinet), the HF horn can be rotated through 90°.
To rotate the HF horn, proceed as follows:
Tools required:
▪ Allen hex torque wrench 2.5 mm.
1. Place the cabinet on its back panel.
2. Depending on the cabinet variant, first undo the four Allen hex
screws holding the front grill and remove the front grill.
3. Undo the four Allen hex screws of the HF horn.
4. Carefully pull out the HF horn and turn it clockwise by 90°.
5. Refit the horn as follows:
1. Make sure the gasket
[G] is seated properly.
2. Refit the horn and tighten the screws with a maximum
torque of 2 N
×
m.
6. Recheck your work and refit the front grill.
d&b 44S Manual 1.1 en
9
