2. Pull out the two connecting rails half their lengths.
3. Retighten the four remaining fixing screws on the extender.
3. Joining the cabinets
1. While a second person renders assistance, insert the
connecting rails of the 24C-E cabinet into the T-slot profiles at
the rear of the 24C cabinet approx. 10 - 20 mm.
2. Reconnect the input connector
[I].
3. Push the Mate-N-Lok plug
[E] of the extender into the
respective connecting socket, as shown in the graphic
opposite.
4. Fully insert the connecting rails into the T-slot profiles.
Þ
Ensure that no connecting wire is crushed between the
edges of the cabinets.
Ensure that the connecting panel of the extender is fully
inserted.
The connecting panel is fully inserted when the front grill of
the 24C cabinet is properly fitted into the panel and the
threaded inserts
[T] are in line with the countersunk drills of
the 24C cabinet.
5. Refit and tighten the two countersunk screws (torx #T20).
6. Tighten the remaining four fixing screws (set screw - torx #T15)
of the connecting rails on the 24C cabinet.
d&b 24C / 24C-E Manual 1.1 en
14
