d&b audiotechnik C4-SUB, Manual Manual

Page: 4 / 8

C4-SUB Manual (3.0E) Page 4 of 8
C4-SUB
The C4-SUB is a compact, hornloaded bandpass design employing
a single 18" driver. It is designed for use with the C4-TOP cabinet
as a part of the C4 system.
The C4-SUB cabinet is constructed from marine plywood and has
an impact resistant paint finish. The front of the loudspeaker
cabinet is fitted with a rigid metal grill covered with a replaceable
acoustically transparent foam, and fitted with catches to the top
and bottom for securing an optional transport lid E7908. The
cabinet incoporates two steel handles and MAN CF4 stud plate
rigging points. Mounted on the rear panel are ratchet strap guide
plates (kelping bars) and four heavy duty wheels.
CAUTION!
Only operate C4-SUB cabinets with a d&b D12 or E-PAC amplifier
in C4-SUB mode or a P1200A mainframe fitted with a C4-SUB
controller module, otherwise there is a risk of damaging the
loudspeaker components.
Connections
1
2
3
4
5
1
2
3
4
5
Sense Drive
n.c.
Connector wiring
The C4-SUB cabinet is fitted with a pair of EP5 connectors. All pins
of both connectors are wired in parallel.
The C4-SUB uses the pin assignments 3/4 and 5 (Pin 5: SenseDrive
- D12 only and in conjunction with 5-wire cables).
Pins 1/2 are designated to d&b full range systems.
Using one connector as the input, the second connector allows for
direct connection to additional cabinets.
The C4-SUB can be supplied with NL4 connectors as an option
using the pin assignment 2+/2–. Pins 1+/1– are designated to d&b
full range systems.
Pin equivalents of EP5 and NL4 connectors are listed in the table
below.
EP5
1 2 3 4 5 (SenseDrive SUB)
NL4
1+ 1– 2+ 2– n.c.
EP5 and NL4 pin assignments