d&b audiotechnik Bi8-SUB, Manual

Page: 6 / 11

To install the fixed cable connection, proceed as follows:
Tools required: Philips screw driver (#PH2).
1. Remove the knockout opening in the cover plate
[1] and
attach the rubber grommet
[2] correspondingly.
2. Insert the connection cable through the rubber grommet.
3. Undo the four screws of the connector panel.
4. Connect the cable wires to the screw terminal.
Þ
Observe the correct polarity!
5. Push the cover plate towards the connector panel until it fits
into place.
6. Finally fix the cover plate together with the connector panel
using all screws.
Step 2 Step 3 Step 4/5 Step 6
Installing the fixed cable connection
NL4 connection with cover plate
Note: Neutrik NL4FC type connectors must be used for this
option.
The cover plate is equipped with two knockout openings to allow
daisy chaining of the loudspeaker.
To use the NL4 connection, proceed in the same manner as
described in the previous section.
Step 1
NL4 cable connection with cover plate [1]
d&b Bi8-SUB Manual 1.1 en 6