Dancover Borneo HE94010, User Manual

Page: 4 / 6

Notice
：

Use 2 pieces AAA size1.5V batteries in the remote control. Remove the battery when not use for long
time, thus the lifespan of remote control can be extended.

Choose the same specification battery when replacing the battery inside, otherwise it may cause
remote control not work, thereby affect the normal use of the heater.

The heater can be still used in normal except remote control function if the remote control is missed
or lost .Please contact service agent for further help if you need the function.

The remote control function may be out of work if there is a barrier between the remote control and
heater .

Replacing the batteries duly so as not to affect the normal use of heater and remote control.
Operation Instructions

Remove all packaging material (including anti ‐ vibration packaging on the lamp) and check the appliance, supply cord and plug
for signs of damage.

Before mounting, note the minimum safe mounting distances and tilt angles as shown in the below must be strictly followed.

The distance between the bottom edge of the appliance and the floor must be at least 1.8 M. See figure 3.

There must be a distance of at least 0.2 M between the appliance and the ceiling, roof or other covers. See figure 3.

There must be a distance of at least 0.5 M at each side between the appliance and walls or the like. See figure 3.

Recommended angle to mounting surface is 45°. See figure 4.

Fix the mounting bracket on the wall first. Ensure that the place to be installed is secure and firm. Or connect the appliance to
a suitable floor stand.

Adjust the desired angle and tighten the hex bolt on the hinge. Regularly the screws’ fixing. Mechanical pressures and
oscillation due to wind or rain can cause your fixing to work loose.

Plug into a suitable power source and operate the via the remote control handset

When not in use for long periods, it is advisable to remove the batteries
Figure1: Mounting bracket (wall bracket) and
anchor dowels provided. Connection from the wall
to the infrared heater.
Figure 2: Connection from the stand to the
infrared heater. The stand shall be purchased
separately.
Figure3: Min. distance to floor, ceiling and wall. Figure 4: Tilt angle