6
5
04
方向舵舵机及连杆安装
Install the rudder steering gear and connecting rod
机翼插入连接杆。
Insert the wings
into the connecting
rod.
在左图所示位置，插
入两根碳杆。
Insert two carbon
rods as shown on
the left.
04-1
04-2
04-3
安装舵机前，取
下舵机插头。因
舵机不同，您可
能需要此步骤。
Remove the
servo plug
before
installing the
servo.Depend-
ing on the
different
servos, you
may need this
step.
在舵机上安装舵臂，然后把舵机装在机身尾
部舵机槽内。
Install the rudder arm on the servo, and
then install the servo in the servo slot at
the rear of the fuselage.
舵机线穿入机身内导管，引导到舱身位置。
最后装回
舵机插头，并注意线序。
Penetrate the servo wires into the guiding tube
inside the fuselage and guide it to the cabin
position.
Finally, install the servo plug, and pay
attention to the order of the wires.
从J板上取下舵角，如左图插到舵
面的预留槽内，用CA胶粘固。
Remove the servo horn from
the J plate, insert it into the
reserved groove of the rudder
surface as shown on the left,
and fix it with CA glue.
04-4
04-5
04-6
04-7
把两根方碳杆插入起落架上的支杆上，连接处少量CA胶粘固。
Insert the two square carbon rods into the bracket rods
on the landing gear, and fix with litte CA glue.
方碳管的另一端插入L型钢丝，然后把钢丝插入机翼上的
预留孔中。此时暂不用胶水粘固。
Insert the other end of the square carbon tube into
the L-shaped steel wire,which need to insert into
the reserved hole on the wing. Don't use glue to fix
at this time.
按03-13，03-14步骤装好左右机翼的支架后，调整左右机翼平直后，在L型钢丝
位置用CA胶粘固。
Install the brackets of the left and right wings according to the steps
03-13 and 03-14, adjust the left and right wings to be straight, and fix
them with CA glue at the position of the L-shaped steel wire.
L型钢丝
L-shaped steel wire
03-10
03-11
03-12
03-13
03-14
03-15
1.在舵机上安装舵臂，舵臂上安装快装接头。
Install the servo arm on the servo, and install the EZ-connector
on the servo arm
2.舵机与舵面通过钢丝连杆连接，钢丝连杆Z型一端穿入舵角，另一
端插入快装接头，然后锁紧快装接头螺丝固定钢丝。
The servo and the rudder surface are connected by a steel wire
connecting rod.
One end of the steel wire connecting rod is inserted into the
servo horn, the other end is inserted into the EZ-connector,
and then tighten the EZ-connector screw to fix the wire.
3.剪切多余钢丝。
3.Cut excess wires
安装方法同步骤04-6。
The installation method is the same as step 04-6.
Epoxy glue
Signal
+ -
