重心位置展示
自攻螺丝
12
Set and Adjust
设置和调试
常规飞行(Normal Flying) 3D飞行 部分飞机支持(3D Flying only support some models)
副翼 Aileron ±（15°-30°） ±40° 或者更大(or larger)
平尾 Elevator ±15° ±40° 或者更大(or larger)
垂尾 Rudder ±15° ±40° 或者更大(or larger)
常用襟翼 Flap （起飞 take-off）15°-20° （降落 Landing）20°-40°
6
部分特殊机型会有V型尾翼，襟翼，前缘机翼或舵面很小等，可以以常规飞行的角度作为参考，在您不确认且没有有经验人员指导
的情况下，我们建议您先以小角度试飞以确认您的设置是否正确。
Some special models will have V-tails, flaps, leading edge wings, etc., which can be used as a reference for conventional
flight angles. If you do not confirm and there is no experienced person to guide you, we recommend that you first test
at a small angle to confirm that your settings are correct.
Rudder
Elevator
Aileron
20°-35°
25°
25°
25°
25°
20°-35°
通常情况下，舵面角度的设置如下：
Usually, the control throws set as below:
≈70-75mm
Display the C.G
self-tapping screws
升降舵
副翼
方向舵
C.G
≈70-75mm
当前缘缝翼 Leading Edge Slat 紧贴机翼时 速度保持不变 升力保持不变。
当打开一定角度的前缘缝翼时，速度减慢，升力提升。（注意不要设置开启角度过大，当角
度太大时，速度过慢，升力会减小。）
When the leading edge slat is close to the wing, the speed remains the same and
the lift remains the same.
When the leading edge slat is opened at a certain angle, the speed decreases and
the lift increases. (Be careful not to set the opening angle too large. When the angle
is too large, the speed will be too slow and the lift will decrease.)
前缘缝翼
Leading Edge Slat
蒙皮详细操作可查看以下链接内容，我们提供了蒙
皮范本（可直接扫二维码）
http://www.dwhobby.com/art/film
For detailed operation of the film, please view the following link.We
provide the example (can directly scan the QR code)
完成以上拼装后即可对飞机进行蒙皮
