后尾轮安装图示 Rear tail wheel installation
后滑撬安装图示 Rear skid installation
起落架及机轮安装图示
Landing Gear and Wheels Installation
后起落架设计为尾轮和滑撬两种方式，分为图17,18两种安装方式，请自行选择安装
14
各完成部件组装 Finished Parts Installation
M4
M5
M3
M1
M2
U2 M0
13
安装尾翼到机身 Install tail wing to fuselage.
15
16
17
18
正面
Front
合页
L-1
玻纤L-1
Fiberglass
玻纤L-1
Fiberglass
螺丝+螺帽
背面
Back
小弹簧
Small Spring
螺丝+螺帽
螺丝+螺帽
19
19.1
19.1
19.2
19.2
自攻螺丝
Self-tapping screw
19.3
19.4
方碳管
Square carbon tube
5x5x150mm
F2-2
小弹簧
拉线支架 Bracing wire bracket
机翼安装图示
Wing Installation
马达座安装图示
Motor Board Installation
马达及桨叶安装图示
Motor and Propeller Installation
像真引擎安装图示
Scale Engine Installation
像真机枪安装图示
Scale Machine Gun Installation
按拼装步骤图在起落架配件包中，找出相应形状的钢
丝、碳管，按图组装。
Find appropriate shape's steel wire, carbon tube
from the landing gear accessories bag.
20
21
马达及像真件安装 Motor and Scale Parts Installation
自攻螺丝
拉线安装 Fasten the end of bracing wire with aluminium buckle
舵机安装示意图 Servo Installation
重心位置展示 CG Position Show
短
short
长
long
单边有两条拉线 ，按图中数字顺序进行安装，两条线用不同颜色表示。
U6
U3
U5
U5
U4
U4
碳管
拉线末端用铝扣固定
马达座根据选用马达的长度，调整马达座伸
出长度，然后用角型铝块加自攻螺定住。
2pcs wires on each side, assemble them according to the numerical order,
different wires with different colors in the picture.
Fasten the end of bracing
wire with aluminium buckle.
Carbon tube
Adjust the extending length of
motor mounting board according
to your motor length, then fasten
with angle aluminum block and
self-tapping screw.
Self-tapping screw
F12
U1
F12
F13
爪牙螺母
Nut F2-2
方碳管
Square carbon tube
裁剪粘贴橡胶条 Cut and stick rubber strip
碳管 Ø8x280mm
Carbon tube
Small Spring
螺丝+垫片
Screw+Spacer
There are two kinds of design for rear landing gear. One is
tail wheel, another one is skid wheel.See Figure 17 and 18,
please choose one design you like for installation.
Screw+Screw Cap
Screw+Screw Cap
U8
Screw+Screw Cap
Hinge
自攻螺丝
Self-tapping screw
3x3x90mm
C.G
≈245mm
22
2
