1
KIT
机身拼装 Assemble the Fuselage
01-1
01-2
机翼拼装 Assemble the Wing
配件图仅做参考用，您收到的实物可能因为
修改/优化的原因导致与图片有略有不同。
Photos shown here just for reference,
the product you received maybe
slightly differ from the photos due to
continuous improvement on products.
在两片A2的反面均匀涂抹泡沫胶。
Apply the foam glue evenly on
the reverse sides of the two
pieces of A2.
把涂好胶水的A2粘到A1的两侧，粘
贴时对齐边缘及各对应的空位。
Glue the glued A2 to both sides
of A1, and align the edges and
corresponding spaces when
pasting.
把转向舵从机身切下，用模型刀切
割转向舵与机身连接处，切出45度
斜面。
Cut the steering rudder from the
fuselage, use a model knife to
cut the connection between the
steering rudder and the fuselage,
and cut a 45-degree slope.
A1
A2
B1
B1
C
D
E
F
G
H1
H2
I
J
B2
A2
A1-2：机身 Fuselage
B1：机翼 Wing
B2：水平尾翼 Horizontal Tail
C：桨叶 Propeller
D：魔术贴 Velcro
E：加强木件
Reinforcement Wooden Parts
F：马达 Motor
G：舵角 Servo Horn
H1-2：钢丝连杆 Steel Wire Linkage
I：热缩管 Heat-shrinkable Tube
J：碳杆 Carbon Rod
01-3
01-4
01-5
02-1
02-2
02-3
把舵机通电回中，并安装
一字型舵臂。然后在舵机
侧面涂抹泡沫胶。
Supply power for the
servo and return it to
center,install a straight
servo horn. Then apply
foam glue on the side
of the servo.
如图所示，把舵机粘
到机身预留孔处。居
中粘贴。
Glue the servo to
the reserved hole of
the fuselage as
shown in the
picture.Pls take care
to paste in the
center.
如图所示，在机身预留的机翼插槽内涂
抹泡沫胶，两面均匀涂抹。
Apply the foam glue evenly on the
reserved wing slots of the fuselage as
shown in the picture.
从木板E上取下机翼支架，如图穿入机
身，并把机翼插入机身，机翼支架和机
翼连接，连接处用泡沫胶粘固。
Remove the wing bracket from the
wooden board E, and insert it into
the fuselage as shown in the
figure.Insert the wing into the
fuselage,connect the wing bracket
and the wing, and fix the joint with
foam glue.
插入另一边机翼，并和机翼支架粘固在
一起。调整机翼居中对齐。
Insert the other wing and glue it to
the wing bracket. Adjust the center
alignment of the wings.
GLUE
GLUE
GL
UE
