此处安装舵机需用桐木块垫起一定高度
Here the servo should be installed with a
paulownia block to a certain height.
用桐木杆和Z型钢丝制作连杆，如下图，一端为Z型，一端为直头，用线绑
扎，胶水粘固。制作时对比机身内舵机到尾部舵角的距离，调整连杆长度。
The connecting rod is made of paulownia rod and Z-shaped steel wire,
as shown in the following figure, one end is Z-shaped, one end is
straight, tied with wire, and glue is glued. Adjust the distance between
the servo and the tail rudder angle in the fuselage during production,
and adjust the length of the connecting rod.
快装接头
水平尾翼连接舵机
M4
M2R
M3
轻木条
M1L
M5
M0玻纤+M0*2
自攻螺丝
自攻螺丝拧
到轻木条上
Screw the
self-tapping screws
onto balsawood
self-tapping screws
电机安装示范，电机座根据所选电机调整伸出长度，
调整好后用角型铝件固定住。
Motor installation demonstration, the motor mounting
adjusts the extension length according to the selected motor,
and after adjustment, it is fixed by the angle aluminum piece.
5
09
Assemble the servo inside the fuselage
机身内舵机安装
10
Install the Motor Mounting and Motor
电机座及电机安装
此处轻木条根据马达座与
角型铝件结合的位置调整
自攻螺丝
11
Install the scale parts
像真件安装
此机型结构为电动马达设计，如您需要安装油动引擎，我们为您提供了2
块油动引擎防火墙，安装需要一定的改装和加固，需要您自己动手修改。
This model is designed for electric motor. If you need to install the
oil engine, we provide you with 2 oil engine firewalls. The installation
needs certain modification and reinforcement. You need to modify it
yourself.
EZ-Connector
Vertical tail connecting servo
垂直尾翼连接舵机
Horizontal tail connecting servo
Here the balsawood strip
is adjusted according to
the position of the motor
mounting and the angled
aluminum piece.
fiberglass
self-tapping screws
另一边相同安装
Same installation
on the other side
Balsawood Strip
