2
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 44.9 cm (17.7 inches)
wide by 68.5 cm (27 inches) high by 51 cm
(20.1 inches) deep. Make sure that you leave
the minimum amount of space between the
appliance and all surrounding walls and vents.
• Allow 12.7 cm (5 inches) of space between the
back of the appliance and the wall. Allow 5
cm (2 inches) between the sides and top of the
appliance and any walls or counter tops.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
INSTALLATION INSTRUCTIONS
BRACKET & MICROWAVE INSTALLATION
Place the bracket on top of the refrigerator. The rear
lip of the bracket should be lined up with the back
edge of the refrigerator, with the two loops facing
up to accept the microwave.
Remove the two screws from the sides of the
microwave, they will be used to secure the
microwave to the bracket. Place the microwave on
the bracket and line up the screw holes in the loops
with the screw holes in the microwave. Secure the
microwave to the bracket using the two screws from
the sides of the microwave and two screws provided
with the refrigerator.
Attach the bracket to the refrigerator using the six
provided screws and the pre-drilled screw holes in
the bracket and the top of the refrigerator.
